Philco PHWK 2002 Bedienungsanleitung PDF herunterladen (Seite 8)

PART 5: USING THE FAST BOIL KETTLE

A. Quick 100 °C boil

1. Plug the power cord into an electric socket. The connection of the kettle will be accompanied by a sound

and the display will be backlit and the water level mark (8) and control buttons (5) will be backlit for a short

time. The current temperature inside the kettle will be shown on the display.

2. Take the kettle off the base (9) and press the open lid button (3).

3. Fill with the required amount of water, close the lid and place the kettle back on to the base. Check that the

kettle lid is properly closed.

4. Press the quick boil button (1) to start the kettle, the pressed button and the water level mark will be lit.

5. As soon as the water in the kettle starts to boil, the heating of the water will automatically be stopped,

which will be accompanied by 5 sound signals. The backlit water volume indicator will turn off.

6. The current water temperature will be shown on the display.

7. The colour of the water level mark backlight changes during the course of the boil depending on the water

temperature (see table below).

Temperature °C Colour

20° Green

30° Green

40° Light blue

50° Light blue

60° Dark blue

70° Dark blue

80° Violet

90° Red

B. Heating water to a required temperature

Using this function you can set a speciﬁ c temperature for the heated water.

1. Fill the kettle with the required amount of drinking water.

2. Repeatedly press the temperature setting button (2) to set the desired water temperature (20, 30, 40, 50,

60,70, 80 or 90 ˚C), the pressed button and the water level mark of the kettle will be lit.

3. The current water temperature will be shown on the display together with the water temperature you set.

4. As soon as the water in the kettle reaches the preset temperature, the heating of the water will automatically

be stopped, which will be accompanied by a sound. The backlit water volume indicator will turn off.

NOTE:

It is not possible to use the heat water to desired temperature function to lower the temperature of the

water in the kettle. If you pour room temperature water at 25 °C into the kettle and set the target water

temperature to 20 °C, the kettle will not run in this mode.

C. Maintaining the set water temperature (KEEP WARM function)

NOTE:

The keep warm function can be used to maintain the water temperature of water heated to a desired

temperature or water boiled and subsequently cooled to the desired temperature. Both these methods

are described further on in this manual in points E and F.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Keine Kommentare

Philco PHWK 2002 Bedienungsanleitung Seite 8